Restoration (rubberizing)

Restorative gumming. Application area

At industrial enterprises, where special equipment and machinery  are intensively used with many different wheels, rollers, sprockets, pistons and other parts with a rubber coating, the problem of their rapid wear exists.

Some rubberized parts of industrial and special equipment are quite unique and you can purchase them from the original equipment manufacturer only as part of a whole unit. It is quite expensive and time consuming.

Wheels, rollers, various sprockets, tracks, pistons and other parts with a damaged coating can be repaired and restored. Moreover, if the coating was originally rubber, replacing it with polyurethane will bring cost and time savings by increasing the life of the products.

We restore parts by replacing a worn coating with a new polyurethane one. This increases not only the durability of the product, but also the reliability and efficiency of the mechanisms in which it is used.

We make restoration of products with a polyurethane coating with a hardness of 71 to 95 units. ShoreA.

• Broaching rollers
• Wheels for warehouse equipment
• Castors and wheels of special machinery
• Paver Tracks
• Guide rollers
• Driving stars
• Concrete pump pistons
• Lugs

And much more

Polyurethane Recovery Pros

Polyurethane is an effective replacement for rubber, due to its properties. Its wear resistance and abrasion resistance are 3 times higher than that of rubber, which improves the operational properties of spare parts by 6-7 times compared to rubber. (More info …)

Products made of polyurethane easily tolerate long alternating loads and temperature changes without permanent deformation, are not susceptible to aging, do not dry out. Highly resistant to aggressive environmental conditions: abrasion, oils, gasoline, organic solvents. Operating temperature range from -50°С to +90°С.